Actuators and bases
Actuators sit on the heating manifold and open or close the individual circuits. The base is a wiring strip that connects them to the hub and supplies them with power.
What it does
The hub, sensors and actuators form a single system — each part has its own role.
Receives a command
The hub decides that a room needs heat.
Opens the circuit
The actuator on the manifold opens the circuit that leads to that room.
Closes
When the room reaches the set temperature, the circuit closes.
The base connects
The wiring strip next to the manifold powers the actuators and links them to the hub.
How it fits into the whole
What it needs to work
- an underfloor heating or radiator manifold
- a base that links the actuators to the hub
What you get
- heat goes only where it is needed
- rooms do not overheat one another
- the heat pump does not heat rooms that nobody uses
How much of what you will need
Enter the number of rooms and circuits — we will show you what your control system is made up of.
Approximately: one sensor for each room and one actuator for each circuit. We will design the exact set according to your manifold.
N2N actuators and bases — data sheet
Specific models with data sheets will be added soon. But we can already design a solution for your house and prepare a quote.
What you ask us
How many actuators do I need?
One for each heating circuit. A larger room may have two or three circuits.
Are they suitable for radiators too?
Yes, the control works for underfloor heating and radiators.
Do I need to break up the floor for them?
No. The actuators are mounted on the existing manifold.
We will design a tailor-made solution for you
Tell us whether you are building or renovating and how many rooms you have. We will prepare a design and a price — free of charge and with no obligation.
NO-OBLIGATION QUOTE