EVERY ROOM
ITS OWN TEMPERATURE
A single thermostat in the hallway decides for the whole house — and suits nobody. N2N room-by-room control gives every room its own temperature: cooler in the bedroom, warmer in the bathroom, and no heating in a room where nobody is.
Illustrative diagram — you set the temperatures as you like
ONE THERMOSTAT
FOR THE WHOLE HOUSE
Every room is heated the same
The thermostat hangs in the hallway and decides for the whole house. What is pleasant in the living room is too much in the bedroom — and too little in the bathroom.
- The bedroom is warm at night, although you want it cooler
- The bathroom does not warm up when you need it most
- Rooms are heated even when nobody uses them for weeks
- The sun warms the south side, the north stays cold
Every room has a mind of its own
Each room has its own sensor. Based on it, the hub opens and closes exactly the heating circuit that belongs to that room.
- You set the temperature for each room separately
- You do not heat where nobody is at the moment
- Rooms do not overheat one another
- Works for underfloor heating and radiators
THREE PARTS,
ONE SYSTEM
The sensor measures
Every room has a small sensor that monitors the actual temperature.
The hub decides
It compares the measured temperature with the one you want and decides where heating is needed.
The actuator opens
On the manifold it opens the circuit to the room that needs heating right now.
You just say what you want
You set temperatures and times on your phone or directly on the sensor.
SYSTEM
COMPONENTS
Hub
The heart of the systemThe control centre to which everything connects. It collects data from the sensors, decides where to heat and stays connected to your phone.
More about the hub →Room sensors
The senses of the systemSmall sensors in individual rooms. They measure what it is really like in the room and send it to the hub — you can also adjust the temperature directly on them.
More about the sensors →Actuators and bases
The hands of the systemActuators sit on the manifold and open or close the individual circuits. The base is a wiring strip that connects them to the hub and supplies power.
More about the actuators →COMFORT
YOU CAN FEEL
Home is just as you want it
A cooler bedroom for sleeping, a warm bathroom in the morning, a children's room exactly as you want it. No compromise for everyone.
No unnecessary heating
Rooms you are not using go into setback mode. The heat pump does not have to heat what nobody uses.
Made for the heat pump
Room-by-room control is built for low-temperature heating — exactly what the N2N heat pump relies on.
WANT IT
AT HOME?
Tell us how many rooms you have — we will prepare a design and a price.